| 1.
|
| Run the Windows DHCP manager utility.
|
| ●
|
| On Windows 2000, click Start, then Settings, and then Control Panel. Open the Administrative Tools folder and run the DHCP utility.
|
|
| ●
|
| Server 2003, click Start, and then click Control Panel. Open the Administrative Tools folder and run the DHCP utility.
|
|
|
| 2.
|
| In the DHCP window, locate and select your Windows server in the DHCP tree.
|
If your server is not listed, select DHCP and click the Action menu to add the server.
|
| 3.
|
| Select your server in the DHCP tree, click the Action menu, and then select New Scope. This runs the Add New Scope Wizard.
|
|
| 4.
|
| In the Add New Scope Wizard, click Next.
|
|
| 5.
|
| Enter a Name and Description for this scope, then click Next.
|
|
| 6.
|
| Enter the range of IP addresses for this scope (beginning and ending IP address), type the subnet mask, and then click Next.
|
| NOTE:
|
If subnetting is used, the subnet mask defines which portion of an IP address specifies the subnet and which portion specifies the client device.
|
|
| 7.
|
| If applicable, type the range of IP addresses within the scope to be excluded by the server, and then click Next.
|
|
| 8.
|
| Set the IP address lease duration for your DHCP clients, and then click Next.
|
HP recommends that all printers be assigned reserved IP addresses. Do this after setting up the scope (see step 11).
|
| 9.
|
| Select No to configure DHCP options for this scope later, and then click Next.
|
To configure DHCP options now, select Yes. Click Next after each step.
| a.
|
| Optional. Type the IP address of the router (or default gateway) to be used by clients.
|
|
| b.
|
| Optional. Type the Domain Name and DNS servers for clients.
|
|
| c.
|
| Optional. Type the WINS server names and IP addresses.
|
|
| d.
|
| Select Yes to activate the DHCP options now.
|
|
|
| 10.
|
| You have successfully set up the DHCP scope on this server. Click Finish to close the wizard.
|
|
| 11.
|
| To configure your printer with a reserved IP address within the DHCP scope, complete the following steps:
|
| a.
|
| In the DHCP tree, open the folder for your scope and select Reservations.
|
|
| b.
|
| Click the Action menu and select New Reservation.
|
|
| c.
|
| Type the appropriate information in each field, including the reserved IP address for your printer. (Note: the MAC address for your HP Jetdirect-connected printer is available on the HP Jetdirect configuration page.)
|
|
| d.
|
| Under Supported types, select DHCP only, and then click Add. (Note: Selecting Both or BOOTP only results in a configuration through BOOTP because of the sequence in which HP Jetdirect print servers initiate configuration protocol requests.)
|
|
| e.
|
| Specify another reserved client, or click Close. The reserved clients added are displayed in the Reservations folder for this scope.
|
|
|
| 12.
|
| Close the DHCP manager utility.
|
|